Q1: The trigger cannot release the piston.
A1: This is the tolerance of some parts. A small number of transmitters will encounter this problem.
You can take one of the XS screws on the side and install it at the top of the trigger, as shown in the figure:
A1: This is the tolerance of some parts. A small number of transmitters will encounter this problem.
You can take one of the XS screws on the side and install it at the top of the trigger, as shown in the figure:
You can adjust the angle of trigger release, i will add screws next time.
If you want to apply for new parts, please contact Z-LIN(Ezekiel lin).
If you want to apply for new parts, please contact Z-LIN(Ezekiel lin).
Q2: The trigger completely unable to move
A2: Download a new catch, or use sandpaper to polish the corners
| nj_catch_1.5_100.stl |
Q3: The trigger cannot rebound.
A3:
When the Rasen chamber is not installed, if the trigger rebound force is insufficient, it means that the spring in the middle of the grip is crooked, please reinstall it.
If the trigger is abnormal when installing Rasen chamber, please polish the trigger:
A3:
When the Rasen chamber is not installed, if the trigger rebound force is insufficient, it means that the spring in the middle of the grip is crooked, please reinstall it.
If the trigger is abnormal when installing Rasen chamber, please polish the trigger:
Download Adjustable trigger:
This requires additional use of three xs screws.
 |  |
| nj_trigger1029.stl |
Q4: Dart weak flight
A4: Check if there is air leaking from the gap
A4: Check if there is air leaking from the gap
spare/Replacement parts
 |  |
|
| ||||
RSS Feed
